كيفية إعداد وضع بروتوكول نقطة إلى نقطة (PPPoA) على جهاز (Tenda) F3 Ethernet (PPPoE)
ملاحظة: إذا لم تكن لديك فكرة عن نوع اتصال شبكتك ، فيرجى الاتصال بـ ISP (مزود خدمة الإنترنت) لتأكيد ذلك.
F3-How%20to%20setup%20PPPOE%20Mode.files/image001.png)
F3-How%20to%20setup%20PPPOE%20Mode.files/image002.png)
F3-How%20to%20setup%20PPPOE%20Mode.files/image003.png)
F3-How%20to%20setup%20PPPOE%20Mode.files/image004.png)
F3-How%20to%20setup%20PPPOE%20Mode.files/image005.png)
F3-How%20to%20setup%20PPPOE%20Mode.files/image006.png)
F3-How%20to%20setup%20PPPOE%20Mode.files/image007.png)
Tenda F3--How to Setup PPPOE Mode
Note: If you have no idea about what is the connection type of your network,
please contact the ISP (Internet Service Provider) to confirm it.
Step
1: Connect the broadband line to
the WAN port of router, and then connect yourcomputer to
LAN1/LAN2/LAN3 port by a cable. Physical connection as
bellow:
Step
2: Configure your computer in dynamic IP, for more
detail, click Here.
Step 3: Setup the router
1.
Open a
browser then type “192.168.0.1” into the Address Bar, press Enter, and you can see the quickest setting page.
2.
Select“PPPOE” option.Type the username
and password from your ISP, and tap “OK”.
Note: If you do not know or forget your user name or password,
please call your ISP to check it.
3. Setup the name and
password of your WI-FI signal in “Wireless Settings”. Set them as you want, then tap “OK” to save this setting.
Note: If you do not want to setup password for your Wi-Fi, keep the “WiFi
password” bar empty.
4.
Then the page will
pop into homepage of your F3. You can see your Wi-Fi status in “Status”. If the information
is shown as below, you can surf the internet now.
NOTE:When the Connection Statusis “connecting”,
please try the steps as below.
1. Tap“Administration”à“WAN Parameters”à“Clone MAC”.
Some
ISPs will bind your broadband account info and a specified MAC address of your
computer together. If you can only access the Internet with a specified
computer without a Router, you can try cloning MAC address for normal Internet
access. By default, it clones the factory MAC address (the MAC address of the
router). If you want to clone the MAC address of the current attached computer,
select “manual” and
input the MAC address of the current attached computer on its right. Then tap “OK” to save this setting.
2.Tap“Administration”à“WAN Parameters”à“WAN speed”.
In WAN Parameters, pelase choose WAN Speed in the
drop-menu. Then click OK to save the settings.
By default, the WAN rate is set as “Auto”. Generally, it is not advisable to change the default value. When the cable length between your Router and the remote device (modem, Router, etc.) is relatively long, you can set WAN rate to 10M FDX or 10MHDX to enhance transmission rate.
